3D model

I created a 3d model of one of my reels and then had it printed out.

I wanted to keep it on the theme of projectors but my projector was too complicated to print. Instead The next best thing was to do one of the reels.

I added a bit of film to to make it look better. My first model that I sent to print was too thin so instead I made it thinker and bigger and I ended up with this:

I am pleased with the results and it did not break. I think I chose the right component to print as it depicts the exact theme of my final piece. 

I like it and shall put it on my window ledge.